1. Attach the drill template (supplied) to the wall where the camera is to be
mounted.
Drill holes in the wall according to the number two holes of the drill
template. Refer to the Figure 2-4.
If you need to route cables through the wall(or ceiling), cut a cable hole
according to the drill template. Skip this step, if you want to route the cables on
the surface of the ceiling.
Secure the junction box to the wall with expansion screws.
Route the cables of the camera.
Connect the video output connector to the monitor. Connect the power
connector to the power supply.
Adjust the image and focus. Please refer to the section 2.3 and 2.4 for
more detailed information.
Hook the camera to the junction box with the safety rope. Refer to the
Figure 2-6.
Secure the camera to the junction box with screws.
To Next Page
Loading...
Need help?
General