Setting the Network Camera over
the LAN
Purpose:
To view and configure the camera via LAN (Local Area Network), you need to
connect the network camera in the same subnet with your PC. Then, install the
SADP or iVMS-4200 software to search and change the IP of network camera.
The following figure shows the cable connection of network camera and PC:
Figure 3-1 Wiring over LAN
Set the IP address of the camera for accessing via LAN.
Steps:
1. To get the IP address, you can choose either of the following methods:
Use SADP, a software tool which can automatically detect network
camera in the LAN and list the device information like IP address, subnet
mask, port number, device serial number, device version, etc., shown in
Figure 3-2.
Use iVMS-4200 software and to list the online devices. Please refer to the
user manual of client software for detailed information.
To Next Page
Loading...
Need help?
General