User Manual of Network Fisheye Camera
69
(1) Set all-day record or segment record:
If you want to configure the all-day recording, please check the All Day
checkbox.
If you want to record in different time sections, check the Customize
checkbox. Set the Start Time and End Time.
Note: The time of each segment can’t be overlapped. Up to 4 segments can
be configured.
(2) Select a Record Type. The record type can be Continuous, Motion Detection,
Alarm, Motion | Alarm, Motion & Alarm, etc.
Continuous
If you select continuous, the video will be recorded automatically according
to the time of the schedule.
Record Triggered by Motion Detection
If you select Motion Detection, the video will be recorded when the motion
is detected.
Besides configuring the recording schedule, you have to set the motion
detection area and check the checkbox of Trigger Channel in the Linkage
Method of Motion Detection Settings interface. For detailed information,
please refer to the Task 1: Set the Motion Detection Area in the Section
5.6.1.
Record Triggered by Alarm
If you select Alarm, the video will be recorded when the alarm is triggered
via the external alarm input channels.
Besides configuring the recording schedule, you have to set the Alarm
Type and check the checkbox of Trigger Channel in the Linkage Method
of Alarm Input Settings interface. For detailed information, please refer to
Section 5.6.3.
Record Triggered by Motion & Alarm
If you select Motion & Alarm, the video will be recorded when the motion
To Next Page
Loading...
Need help?
General
Weight and Dimensions
