UM DS-2CE7xH0T-ITxxx Series Turret 052020NA 5
•
Input voltage should meet both the SELV (Safety
Extra Low Voltage) and the Limited Power Source
with 12 VDC according to the IEC60950-1 standard.
Refer to
technical specifications for detailed
information.
•
Do not connect multiple devices to one power
adapter to avoid overheating or a fire hazard
caused by overload.
•
Make sure that the plug is firmly connected to the
power socket.
•
Make sure that the device is firmly fixed if wall
mounting or ceiling mounting is used.
•
If smoke, odor, or noise rise from the device, turn
off the power at once, unplug the power cord, then
contact the service center.
•
Non-professional personnel should never attempt
to disassemble the camera.
1.6.2
Cautions
•
Do not drop the camera or subject it to physical
shock.
•
Do not touch sensor modules with fingers.
•
Do not place the camera in extremely hot, cold (the
operating temperature shall be -40° to 60° C),
dusty, or damp locations, and do not expose it to
high electromagnetic radiation.
•
If cleaning is necessary, use a clean cloth with a bit
of ethanol, and wipe it gently.
•
Do not aim the camera at the sun or extra bright
places.
•
The sensor may be burned out by a laser beam, so
if any laser equipment is in use, make sure that the
surface of the sensor will not be exposed to the
laser beam.
•
To avoid heat accumulation, good ventilation is
required for the operating environment.
•
Keep the camera away from liquid while in use for
non-waterproof device.
•
While in delivery, the camera shall be packed in its
original packing or packing of the same material.
1.6.3
Mark Description
Table 0-1 Mark Description
To Next Page
Loading...
Need help?
General
