Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
56
9.12.1 Set Manual Compass
Use a direction indicating device to determine the North at the device location, and set the North
for the device.
Before You Start
Use a direction indicating device to determine the north at the device location.
Steps
1. Select the PT Mode as Manual.
2. Adjust the tilt position of the device to 0 by controling the up arrow and down arrow on the PTZ
panel.
3. Adjust the pan position to show the live view of the north direction by controling the left arrow
and right arrow on the PTZ panel.
4. Click Set as North.
9.12.2 Set Auto Compass
For the device that has built-in e-compass, the compass can automatically tell the north direction
for the device.
Before You Start
Electromagnetic interference may affect the accuracy of the e-compass. Use manual compass if
electromagnetic interference occurs in the device installation environment.
Steps
1. Select the PT Mode as Auto.
2. Click Calibrate to synchronize the north of the device with that of the e-compass.
9.13 Set Power Off Memory
This function can resume the previous PTZ status of device after it restarting from a power-off.
Steps
1. Go to Configuration → PTZ → Basic Settings.
2. Select Resume Time Point. When the device stays at one position for the set resume time point
or more, the position is saved as a memory point. The device returns to the last memory point
when it restarts.
3. Click Save.
To Next Page
Loading...
Need help?
General
