Please get familiar with the installation environment before you wiring, including the
wiring distance, wiring environment, keeping magnetic-field interference away, etc.
Please make sure the rated voltage of the cable is higher than that the device
requires, thus guarantee the device can work normally when the voltage instability
occurs.
Please avoid the interrupt line connection
It’s recommended to use a single complete cable for the device connection; if not,
reinforce and protective measures should be taken for the wiring point between two
cables, in case the circuit aging will make the device work abnormally.
Make sure the video cable and the signal transmission cable are well protected. And
pay attention to reinforce and protective measures during wiring.
Make sure the cables are not too redundant or being stretched too tight.
Under normal circumstances, the wiring is completed by the professional technicians.
However, when the device cannot work normally, you can check the above
information to look for reason.
4.3 Bracket Installation
Steps:
2. Drill four φ16.5 holes in the wall according to the screw hole sites of the racket.
To Next Page
Loading...
Need help?
General
