HIKVISION DS-7108NI-Q1/8P/M User Manual

Figure 6-6 DDNS
2. Turn on Enable.
3. Select a DDNS type.
4. Enter parameters including service address, domain name, etc.
5. Click Apply.
What to do next
You can view DDNS status in Status.
6.2.3 NAT
Two ways are provided for port mapping to realize the remote access via the cross-segment
network, UPnP™ and manual mapping.
Before You Start
Enable the UPnP™
funcon of your router if UPnP™ is required. When the device network working
mode is mul-address, the default device route should be on the same network segment as the
LAN IP address of the router.
Steps
1. Go to
Conguraon → Network → General → NAT .
Network Video Recorder User Manual
42

HIKVISION DS-7108NI-Q1/8P/M Specifications

General

DC voltage	48 V
Power supply type	DC
Power consumption (typical)	75 W
Operating temperature (T-T)	-10 - 55 °C
Operating relative humidity (H-H)	10 - 90 %
Video input channels	8 channels
USB 2.0 ports quantity	2
VGA (D-Sub) output ports	1
Supported network protocols	TCP/IP, DHCP, Hik-Connect, DNS, DDNS, NTP, SADP, SMTP, UPnP
Ethernet LAN	Yes
Ethernet interface type	Fast Ethernet
Maximum HDD capacity	6000 GB
Video compression formats	H.264, H.265

Weight and Dimensions

Depth	225 mm
Width	260 mm
Height	48 mm
Weight	1000 g