HIKVISION DS-7108NI-Q1/8P/M User Manual

Chapter 7 Maintenance
7.1 Restore Default
Steps
1. Go to Maintenance .
2. Select the restoring type.
Simple Restore
Restore all parameters, except the network (including IP address, subnet mask, gateway,
MTU, NIC working mode, default route, server port, etc.) and user account parameters, to
the factory default
sengs.
Factory Defaults
Restore all parameters to the factory default sengs.
Restore to Inacve
Restore the device to the inacve status, and leave all sengs unchanged except restoring
user accounts.
3. Click Yes. The device will reboot automacally.
7.2 Search Log
The operaon, alarm, excepon and informaon of video recorder can be stored in logs, which can
be viewed and exported at any
me.
Steps
1. Go to Maintenance.
2. Click More.
3. Go to Log
Informaon.
4. Set the search condions.
5. Click Search.
7.3 System Service
Steps
1. Go to Maintenance .
2. Click More.
3. Go to System Service → System Service .
4. Congure the parameters as your desire.
RTSP
You can
specically secure the stream data of live view by seng the RTSP authencaon.
Network Video Recorder User Manual
70

HIKVISION DS-7108NI-Q1/8P/M Specifications

General

DC voltage	48 V
Power supply type	DC
Power consumption (typical)	75 W
Operating temperature (T-T)	-10 - 55 °C
Operating relative humidity (H-H)	10 - 90 %
Video input channels	8 channels
USB 2.0 ports quantity	2
VGA (D-Sub) output ports	1
Supported network protocols	TCP/IP, DHCP, Hik-Connect, DNS, DDNS, NTP, SADP, SMTP, UPnP
Ethernet LAN	Yes
Ethernet interface type	Fast Ethernet
Maximum HDD capacity	6000 GB
Video compression formats	H.264, H.265

Weight and Dimensions

Depth	225 mm
Width	260 mm
Height	48 mm
Weight	1000 g