Network Video Recorder User Manual
58
Chapter 6 Event
6.1 Normal Event Alarm
6.1.1 Configure Motion Detection Alarms
Motion detection enables the device to detect the moving objects in the monitored area and
trigger alarms.
Steps
1. Go to System → Event → Normal Event → Motion Detection.
2. Select a camera.
3. Check Enable.
4. Set the motion detection rule.
For cameras have
human and vehicle
detection function.
Click Draw Area to draw the detection area(s) on the preview screen.
Set Detection Target as Human or Vehicle to discard alarms which
are not triggered by human body or vehicle.
For cameras do not
have human and
vehicle detection
function.
Click Full screen to set the full-screen as the detection area, or drag
on the preview screen to draw the customized detection area.
5. Set Sensitivity
Sensitivity
Sensitivity ranges from 0 to 100. It allows you to calibrate how readily movement triggers the
alarm. A higher value results in the more readily to triggers motion detection.
6. Set the arming schedule. Refer to Configure Arming Schedule.
7. Set linkage actions. Refer to Configure Linkage Actions.
6.1.2 Configure Video Loss Alarms
Video loss detection detects video loss of a channel and takes alarm response action(s).
Steps
1. Go to System → Event → Normal Event → Video Loss.
2. Select a camera.
3. Check Enable.
4. Set the arming schedule. Refer to Configure Arming Schedule.
To Next Page
Loading...
Need help?
General
