13
Audible Tamper Alarm
While enabled, the system will alert with buzzer for the tamper alarm. Regardless of whether it
is enabled or not, the tamper alarm will be normally pushed to Cloud (for APP) and ARC.
Panel Lockup Button
All functions of AX HYBRID PRO will be frozen after it is enabled. This function can only be
enabled by users with installer permission.
Bypass on Re-Arm
While enabled, after the detector is bypassed, if its faults are restored and the linked area is
armed, the detector will automatically arm.
Polling Loss Times
Set the maximum number of times for polling loss of peripherals and detectors. The system will
report fault if the time is over the limit. The status of these peripherals and detectors will be
shown as offline.
Motion Detector Restore
Motion detectors include all PIR detectors.
-Disable: No automatic restore.
-Immediate After Alarm: Motion detectors automatically restores immediately after the alarm
and reports to Cloud (for APP) and ARC.
-After Disarm: Motion detectors automatically restores after disarming and reports to Cloud
(for APP) and ARC
Jamming Sensitivity Settings
The device will detect RF interference and push messages when the RF interference interferes
with communication. You can adjust the detection sensitivity.
Enable PD6662
Enable PD6662 standard. Functions that do not meet the standard will not take effect.
Keypad Logout
After the keypad enters the programming page, if there is no key operation, it will exit the
programming page after reaching this time.
Schedule and Timer Settings
You can set the alarm schedule. The zone will be armed/disarmed according to the configured
time schedule.
Steps
1. Click System → System Options → Schedule & Timer to enter the Schedule & Timer page.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
