72
Transmission Mode
Select the Transmission Mode as TCP or UDP. UDP is recommended by the SIA DC-09
standard.
Impulse Counting Time
After the selected time, the system will retry to transmit.
Attempts
Set the number of retry attempts.
Polling Option
Set the polling rate with the range from 10 to 3888000 seconds. The system will report fault if
the time is over the limit. The status of device will be shown as offline.
Periodic Test
After enabling, you can set the time interval, setting how often to send a test event to the
ARC to ensure the connection.
Companies
Select the support company as None, Hungary-Multi Alarm Receiving Company or French
Alarm Receiving Company.
Cloud Service Settings
Steps
1. In the site, tap the AX HYBRID PRO and then log in to the device (if required).
2. Tap → Communication Parameters→ Cloud Service Settings to enter the page.
3. Select the Communication Mode.
Auto
The system will select the communication mode automatically according to the sequence of,
wired network, Wi-Fi network, and cellular data network. Only when the current network is
disconnected, will the device connect to other network.
Wired Network & Wi-Fi Priority
The connection priority order from high to low is: wired network, Wi-Fi, cellular data
network.
Wired &Wi-Fi
The system will select wired network first. If no wired network detected, it will select Wi-Fi
network.
Cellular Data Network
The system will select cellular data network only.
To Next Page
Loading...
Need help?
General
