HIKVISION iDS-2CD9856-BIS Operation Manual

Before You Start
Download the SNMP soware and manage to receive the device informaon via SNMP port.
Steps
1.
Go to
Conguraon → Network → Network Parameters → SNMP .
2.
Check Enable SNMPv1/Enable SNMP v2c/Enable SNMPv3.
Note
●
The SNMP version you select should be the same as that of the SNMP soware.
●
Use dierent versions according to the security levels required. SNMP v1 is not secure and
SNMP v2 requires password for access. SNMP v3 provides encrypon and if you use the third
version, HTTPS protocol must be enabled.
3.
Set the SNMP parameters.
4.
Click Save.
6.5 Set QoS
QoS (Quality of Service) can help improve the network delay and network congeson by seng
the priority of data sending.
Note
QoS needs support from network devices such as routers and switches.
Steps
1.
Go to Conguraon → Network → Network Parameters → QoS .
2.
Enable Video/Audio DSCP, Event/Alarm DSCP, and Management DSCP according to the actual
needs.
Note
Network can idenfy the priority of data transmission. The bigger the DSCP value is, the higher
the priority is. Same sengs need to be set in the router for conguraon.
3.
Click Save.
6.6 Set IEEE 802.1X
IEEE 802.1X is a port-based network access control. It enhances the security level of the LAN/
WLAN. When devices connect to the network with IEEE 802.1X standard, the
authencaon is
needed.
Steps
1.
Go to
Conguraon → Network → Network Parameters → 802.1X .
Network Trac Camera Operaon Manual
37

HIKVISION iDS-2CD9856-BIS Specifications

General

Brand	HIKVISION
Model	iDS-2CD9856-BIS
Category	Security Camera
Language	English