Quick Operation Guide of DS-7600NI-SE&V(P) Series NVR
15
Using the Start Wizard
By default, the Setup Wizard starts once the NVR has loaded, as shown in Figure below.
Start Wizard Interface
Operating the Setup Wizard:
1. The Setup Wizard can walk you through some important settings of the NVR. If you don’t want to use the
Setup Wizard at that moment, click the Cancel button. You can also choose to use the Setup Wizard next
time by leaving the “Start wizard when NVR starts?” checkbox checked.
2. Click Next button on the Wizard window to enter the Login window.
Login Window
3. Enter the admin password. By default, the password is 12345.
4. To change the admin password, check the New Admin Password checkbox. Enter the new password and
confirm the password in the given fields.
5. Click the Next button to enter the date and time settings window.
To Next Page
Loading...
Need help?
General
