HIMA HIMax X-COM 01 E User Manual

4 Start-Up X‑COM 01 E
Page 26 of 46 HI 801 566 E Rev. 13.00.00
4 Start-Up
This chapter describes how to install and configure the module. For further details, refer to the
system manual (HI 801 001 E).
4.1 Mounting
Observe the following points when mounting the module:
▪ Only operate the module with the appropriate fan components. For further
details, see the system manual (HI 801 001 E).
▪ Only operate the module with the suitable connector board. For further details,
see Chapter 3.7.
4.2 Mounting and Removing the Module
This chapter describes how to replace an existing module or mount a new one.
When removing the module, the connector board remains in the HIMax base plate. This saves
additional wiring effort at the clamp terminals since all field terminals are connected via the
connector board of the module.
4.2.1 Mounting a Connector Board
Tools and utilities:
▪ Screwdriver, cross PH 1 or slotted 0.8 x 4.0 mm.
▪ Matching connector board.
To install the connector board
1. Insert the connector board into the guiding rail with the groove facing upwards (see following
drawing). Fit the groove into the guiding rail pin.
2. Place the connector board on the cable shield rail.
3. Secure the captive screws to the base plate. First screw in the lower screws than the upper
ones.
To remove the connector board
1. Release the captive screws from the base plate.
2. Carefully lift the lower section of the connector board from the cable shield rail.
3. Remove the connector board from the guiding rail.

HIMA HIMax X-COM 01 E Specifications

General

Brand	HIMA
Model	HIMax X-COM 01 E
Category	Control Unit
Language	English