HIMA HIMax X-COM 01 E User Manual

X‑COM 01 E Table of Contents
HI 801 566 E Rev. 13.00.00 Page 3 of 46
Table of Contents
1 Introduction 5
1.1 Structure and Use of This Manual 5
1.2 Target Audience 5
1.3 Presentational Conventions 6
1.3.1 Warning Messages 6
1.3.2 Useful Additional Information 7
2 Safety 8
2.1 Intended Use 8
2.1.1 Environmental Conditions 8
2.1.2 ESD Protective Measures 8
2.2 Residual Risk 8
2.3 Safety Precautions 8
2.4 Emergency Information 8
3 Product Description 9
3.1 Replacement and Compatibility 9
3.1.1 Downgrade 9
3.2 Safety Function 10
3.2.1 Response in the Event of a Fault 10
3.3 Scope of Delivery 10
3.4 Type Label 11
3.5 Structure 12
3.5.1 Block Diagram with X-CB 001 02 Connector Board 12
3.5.2 Block Diagram with X-CB 001 04 Connector Board 13
3.5.3 Processor System 14
3.5.4 Ethernet Switch 14
3.5.5 Ethernet Interface 14
3.5.6 Fieldbus Interfaces on the X-CB 001 02 Connector Board 14
3.5.7 Automation Network and Fieldbus Interfaces on the X-CB 001 04 Connector Board 15
3.5.8 Indicators 16
3.5.9 Module Status Indicators 18
3.5.10 Redundancy Indicators 18
3.5.11 System Bus Indicators 19
3.5.12 Fieldbus and Automation Network Indicators 19
3.5.13 Ethernet Indicators 20
3.6 Product Data 21
3.7 Connector Board 22
3.7.1 Ports on the X-CB 001 02 Connector Board 22
3.7.2 Ports on the X-CB 001 04 Connector Board 24
4 Start-Up 26
4.1 Mounting 26
4.2 Mounting and Removing the Module 26
4.2.1 Mounting a Connector Board 26
4.2.2 Mounting and Removing a Module 29
4.3 Configuring the Module in SILworX 31

HIMA HIMax X-COM 01 E Specifications

General

Brand	HIMA
Model	HIMax X-COM 01 E
Category	Control Unit
Language	English