10
STEP 5 Proceed through the Screen Setup Menu
AUTO GEOMETRIC CORRECTION
NOTE:
ensure that Laser TV and your mobile device are con-
nected to the same wireless network before starting correction.
1. Adjust the Laser TV position by using the levelling feet as
needed, and ensure the frame of the screen is located inside
the rectangular border.
2. Click Next to continue.
3. Scan the QR Code with your mobile device to begin
Automatic Geometric Correction. After a few moments, an
alignment grid pattern will appear on the screen.
4. Click "+" on your mobile device to take a photo of the full
screen. For best results, stand about 10 feet away from the
screen and use landscape mode.
5. Click "upload" on your mobile device to complete the
Automatic Geometric Correction.
Alignment grid
NOTE:
• Stand in front of the screen to take the phote,no deviation of
more than 25° permitted.
• The whole screen should be fully visible on the photo,
including the frame of the screen.
• All the 16 points in the alignment grid should be all in focus
when taking the photo and visible on the photo used for
correction.
• The screen image should take up at least 60% of the overall
photo size.
PROJECTION MODE
If you need to ip the image over top-to-bottom and/or left-to-
right, select the Projection Mode.
To Next Page
Need help?
General