12
Yes, this is normal. The Laser TV is initializing and searching for
previous setting information.
The light output of the projector is disabled.
In this case, if the power indicator illuminates red light for 5
times, please check whether the foreign object detection window
is covered or dirtied. If so, uncover or carefully clean the foreign
object detection window.
No sound or picture
1. Check if the power cord is plugged into a powered AC outlet.
2. Press the Power button on the remote control to activate
the unit from 'Standby' mode.
3. Check to see if the LED light is on or not. If it is, then the
Laser TV is receiving power.
I have connected an external source to my Laser TV and I get
no picture and/or sound
1. Check for the correct output connection on the external
source and for the correct input connection on the Laser TV.
2. Make sure you have made the correct selection for the input
mode for the incoming signal.
The picture is normal but there is no sound
1. Check the volume settings.
2. Check if 'Mute' mode is set to On.
Sound but no picture or black and white picture
1. If the picture is black and white, unplug the Laser TV from the
AC outlet and replug it after 60 seconds.
2. Check that the Colour Saturation is set to 50 or higher.
3. Try different channels.
The sound and/or picture is distorted or appears wavy
1. An electric appliance may be affecting the Laser TV. Turn off
any appliances that are nearby and move it farther away from
the Laser TV.
2. Insert the power plug of the Laser TV set into another power
outlet.
The sound and picture is blurry or cuts out
1. If using an external antenna, check the direction, position and
connection of the antenna.
2. Adjust the direction of your antenna or reset or ne tune the
channel.
The plastic cabinet makes a "clicking" type of sound
The 'click' sound can occur when the temperature of the Laser
TV changes. This change causes the Laser TV cabinet to
expand or contract, which makes the sound. This is normal and
the Laser TV is OK.
The remote control does not work
1. Conrm that Laser TV still has power and is operational.
2. Change the batteries in the remote control.
3. Check if the batteries are correctly installed.
To Next Page
Loading...
Need help?
General