Initial Setup
Turning the TV On for the First Time
1.
completed all the connections.
2. Switch on the POWER ON/OFF at the bottom of the TV.
Then the TV switches to on mode.
Connect the mains cable to the mains socket after you have
Always disconnect the TV from the mains socket when not in
use for a long period of time.
To completely disconnect the mains power, please remove the
mains plug from the mains socket or switch off the
POWER ON/OFF switch.
3.
Setup Wizard -1 menu.
4. Press /
/
buttons to select the local time zone where you
operate the TV and press OK to confirm.
Then press button to enter the Setup Wizard-2 menu.
Or you can press Exit button to exit the wizard. In Wizard-2,
press buttons to select Home Mode or Shop Mode.
Press button to enter next step or press button to return
previous step.
6. Press /
enter the next wizard and the TV will start to search the
programs automatically.
8. After scan, the wizard will display congratulations and then
you can press OK button to exit the wizard.
The first time you turn the TV on, it will go straight into the
Setup Wizard -1
VIC
QLD
SA
WA
TAS
NT
NSW/ACT
Please set the local time zone for your TV set:
Select
Next
Exit
EXIT
Setup Wizard -2
Shop Mode
Home Mode
Please select your mode
Select
Next
Exit
EXIT
Back
Setup Wizard -
Skip Scan
Scan
Channel Installation:
Select
Next
Exit
EXIT
Back
Setup Wizard -
3
Channel Installation:
Status: Scanning...
ATV Program Installed: 4
DTV Program Installed: 3
Cancel
EXIT
Setup Wizard -
4
Congratulations!!
Completed Initial Setup.
Please press [OK] to exit the wizard.
Back
17
To mains socket
5
Select` Home Modes` when installing this TV in your home
All available TV channels are stored. This display shows
the progress of the tuning and the number of channels.
If you want to cancel the scan , please press Exit button.
7
To Next Page
Loading...
Need help?
General