Reversing the door
Warning!
The fridge has been built with the door hinges on the right. If you wish to change the opening
direction, please unplug the fridge from its electrical outlet, empty everything in the fridge,
including shelves, food, etc. All parts removed must be saved to reinstall the door.
Before you start laying the refrigerator on its back in order to gain access to the base, you should
rest it on soft foam packaging or similar material to avoid
any damage at the rear
of the refrigerator.
1. Stand the refrigerator, first remove the
screw cover and unscrew the upper
hinge cover which is at the top right
corner of the refrigerator, and use a putty
knife or thin-blade screwdriver to
prize the screw hole cover which is at the
top left corner of the refrigerator.
2. Unscrew the flange screws which are
used for fixing the right upper hinge part
(please support the upper door with your
hand when doing it). Lift the upper door
and place it on a padded surface to
prevent it from scratching.
3. Remove the upper hinge axis, transfer it
to reversed side and tighten securely,
then put it in a safe place.
4. Remove the two flange screw, then
remove the middle hinge that hold the
lower door in place. Lift the lower door
and place it on a padded surface to
prevent it from scratching.
screw hole cover
screw cover and screw
upper hinge cover (right)
flange screws
right upper hinge part
To Next Page
Loading...
Need help?
General
