Energy Saving tips
1. Do not place warm foods into the appliance. Allow warm foods to cool first. Do not install the
appliance near cookers, radiators or other sources of warmth. High ambient temperatures cause
longer, more frequent operation of the compressor.
2. In order to make the cooling system work efficiently, please make sure the side plates and
back plate of the product are with some distance from the wall. It is strongly recommended that its
back is 75mm away from the wall, its sides at least have a space of 100mm separately and the
height from over its top is not less than 100mm.
3. When the product works, please do not open the door too often or leave the door open any
longer than necessary.
4. Do not set temperature any colder than necessary.
5. The direct cooling refrigerator (with a freezer) needs to be defrosted when necessary. This will
improve the cold transfer and reduce energy consumption.
6.
Refer to page 5 which shows the right combination of the drawers, crisper and shelves which can
lead to the more energy efficiency. If users adjust the combination, energy consumption may be affected.
7. Store food logically. Do not exceed the storage period specified.
Care and maintenance
z Cleaning method
1. Please wipe the refrigerator with a soft cloth, use warm water or neutral detergent
2. Then dry it with another cloth.
3. For any hard to remove stains such as glue or oil we recommend to use a diluted solution of eucalyptus oil.
4. It is advisable to clean your refrigerator once a month.
z Maintenance of plastic parts
If any of the plastic parts in or around the refrigerator are contaminated by spillage. We recommend
cleaning immediately to avoid any cracks and or bad odours.
z Electric parts
Notes:
1. For the sake of safety, please disconnect the plug off before cleaning.
2. Avoid spraying water directly onto the refrigerator this could cause rust and weaken the insulation.
3. We recommend using a neutral detergent or diluted eucalyptus for cleaning. Do not use the following
as damage to the lacquer coat and plastic surfaces may occur:
To Next Page
Loading...
Need help?
General
