Remove transport packaging
The appliance and the interior fittings are protected for transportation. Pull off the adhesive
tape on the left and right side of the door. You can remove any remnants of adhesive using
diluted eucalyptus oil. Remove all adhesive tape and packing pieces from the interior of the
appliance.
Positioning
Position the appliance away from sources of heat such as stoves, radiators, direct sunlight etc.
Maximum performance and safety are guaranteed by maintaining the correct indoor
temperature for the class of unit concerned, as specified on the rating plate
. This appliance
performs well from 10°C to 43°C. The Appliance may not work properly if it is left for a longer
period at a temperature above or below the indicated range.
IMPORTANT!
There is a need of good ventilation around the fridge for easy dissipation of heat, high efficiency
of refrigeration and low power consumption. For this purpose, sufficient clear space should be
available around the fridge. We advise to leave a gap of 75mm separating the back of the
fridge to the wall, at least 100mm of space at its two sides, height of over 100mm from its top
and a clear space upfront to allow the doors to open
160 degrees.
Appliances must not be exposed to rain. Sufficient air must be allowed to circulate in the lower
rear section of appliances, as poor air circulation can affect performance.
Starting up
Insert the plug of the connection lead into the plug socket with protective earth contact. When
the refrigerator compartment door is opened, the internal lighting is switched on.
To Next Page
Loading...
Need help?
General
