English
– 18 –
MAINTAINING YOUR DRILL PRESS
For our own safety, turn the switch OFF and remove the plug
from the power source outlet before maintaining or lubricating
your drill press.
Frequently blow out, using an air compressor or dust vacuum,
any dust that accumulates inside the motor. A coat of paste
wax applied to the table and column will help to keep the
surface clean & help avoid rust.
To avoid shock or fire hazard, if the power cord is worn
or cut on any way, have it replaced immediately.
LUBRICATION
All of the drill press ball bearings are packed with grease at
the factory. They require no further lubrication. Periodically
lubricate the gear and rack for the table elevation. Lower
spindle to maximum depth and oil moderately once every
three months.
BATTERIES
Check the laser batteries regularly to avoid deterioration.
Remove the batteries if you will not be using the laser for an
extended time.
WARNING
MAINTENANCE
To Next Page
Loading...
Need help?
General
