30
English
30. WARNING: It is important to
support the work piece properly
and to hold the saw fi rmly to
prevent loss of control which
could cause personal injury. Fig. 4
illustrates typical hand support of
the saw.
31. Place the wider portion of the saw
base on that part of the work
piece which is solidly
supported, not on the
section that will fall off when
the cut is made. As
examples, Fig. 5 illustrates
the RIGHT way to cut off the
end of board, and Fig. 6 the
WRONG way. If the work piece is short or
small, clamp is down. DON’T TRY TO HOLD
SHORT PLACES BY HAND!
32. Never attempt to saw with the circular saw
held upside down in a vise. This is extremely
dangerous and can lead to serious accidents
(Fig. 7).
33. When the brake becomes ineff ective, replace
the carbon brushes with new ones.
CAUTION ON LITHIUM-ION BATTERY
To extend the lifetime, the lithium-ion battery equips with the
protection function to stop the output.
In the cases of 1 to 3 described below, when using this product, even if
you are pulling the switch, the motor may stop. This is not the trouble
but the result of protection function.
1. When the battery power remaining runs out, the motor stops.
In such case, charge it up immediately.
2. If the tool is overloaded, the motor may stop. In this case, release
the switch of tool and eliminate causes of overloading. After that,
you can use it again.
3. If the battery is overheated under overload work, the battery
power may stop.
In this case, stop using the battery and let the battery cool. After
that, you can use it again.
Furthermore, please heed the following warning and caution.
Fig. 4
A TYPICAL ILLUSTRATION
OF PROPER HAND
SUPPORT
Fig. 5
Fig. 6
Fig. 7
Vise
000Book_C18DSL_ChS.indb 30000Book_C18DSL_ChS.indb 30 2015/3/3 13:21:362015/3/3 13:21:36
To Next Page
Loading...
Need help?
General
