English
18
METHODS OF OPERATION
This Nailer is equipped with the push lever and does not operate unless the push lever is
depressed (upward position).
There are two methods of operation to drive nails with this Nailer.
They are:
1. Intermittent operation (Trigger fire):
2. Continuous operation (Push lever fire):
(1) Intermittent operation (Trigger fire)
1 Position the nail outlet on the workpiece
with finger off the trigger.
2 Depress the push lever firmly until it is
completely depressed.
3 Pull the trigger to drive a nail.
4 Remove finger from the trigger.
To drive another nail, move the Nailer along
the workpiece and repeat this procedure.
(2) Continuous operation (Push lever fire)
1 Pull the trigger with the Nailer off the
workpiece.
2 Depress the push lever against the
workpiece to drive a nail.
3 Move the Nailer along the workpiece with
a bouncing motion.
Each depression of the push lever will drive
a nail.
As soon as the desired number of nails have
been driven, remove finger from the trigger.
WARNING
䢇 Keep your finger off the trigger except during fastening
operation, beacuse serious injury could result if the push lever
accidentally contacts you or others in work area.
䢇 Keep hands and body away from the discharge area. The
Stapler with contact trip mechanism may bounce from the
recoil of driving a fastener and unwanted subsequent fastener
may be driven, possibly causing injury.
䢇 Some types of loaded staples can spark out of the muzzle
during a nail driving operation. Exercise caution!
THE OPTIONAL SEQUENTIAL TRIP MECHANISM (SINGLE SHOT PARTS) is for use where
precision fastener placement is desired and must be operated in accordance with the
following “Method of Operation”.
Push
Lever
Trigger
Previously
pull the
trigger
2
3
3
1
To Next Page
Loading...
Need help?
General
