User Manual - CODA56 - Cable Modem 7
Rear Panel (Hardware Connections)
The rear panel has the connections shown in the following figure:
Figure 3: CODA56 Cable Modem Rear Panel
2.5G This port connects your computer and other network devices, using
Category 5 or 6 Ethernet cables with RJ45 connectors.
RESET Use this button to reboot or restore your CODA56 cable modem
configuration settings.
To reboot (or restart) the cable modem:
1. Insert the end of a paper clip or other small object with a narrow tip into
the Reset opening on the back of your CODA56 modem.
2. Press and hold the Reset button for three or four seconds only to reset the
CODA56. The CODA56 resets, using your existing settings.
To restore the cable modem configuration back to factory
default settings:
1. Insert the end of a paper clip or other small object with a narrow tip into
the Reset opening of the back of your CODA56 modem.
2. Press and hold the Reset button for 10 seconds or more to restore* the
CODA56 back to its factory default settings. *NOTE: If you restore the
CODA56, any modified settings cannot be recovered.
CABLE Use this to connect to the Internet via a coax cable.
POWER Use the POWER port to connect the included 12 volt DC power adapter
with your CODA56.
Power
Cable
Reset
2.5G
Chapter 1 Hardware Overview
To Next Page
Loading...
Need help?
General
