instrument panel controls the
brightness of the instrument panel
lights. Turn the knob to adjust the
brightness.
Push the button between the center
vents to turn on the hazard warning
lights (four-way flashers). This
causes all four outside turn signals
and both turn indicators in the
instrument panel to flash. Use the
hazard warning lights if you need to
park in a dangerous area near heavy
traffic, or if your vehicle is disabled.
The instrument panel will illuminate
with reduced brightness when you
open the driver’s door. The
brightness will increase slightly
when you insert the key in the
ignitionswitch,thengotonormal
brightness when you turn the
ignition switch to the ON (II)
position.
If you do not insert the key in the
ignition switch after opening the
driver’s door, the illumination turns
off about 30 seconds after you close
the door.
If you insert the key but do not turn
the ignition switch to the ON (II)
position, the illumination turns off in
about 10 seconds.
To reduce glare at night, the instru-
ment panel illumination dims when
you turn the light switch to or
knob fully to the right until you hear
a click will cancel the reduced bright-
ness.
Instrument Panel Brightness Hazard Warning Button
Instrument Panel Brightness, Hazard Warning Button
Instruments and Controls
71
SELECT/RESET KNOB
０６／０７／０７ １５：２０：４４ ３１ＳＤＮ６４０ ００７６
The select/reset knob on the
. Turning the select/reset
To Next Page
Loading...
Need help?
General
