Part No: 4417341 Revision 10 Installation Manual 10
954 SmartServo FlexLine
Safety Instructions
2.3.1. Safety Instructions
See the safety instructions shipped with the device for installation, commissioning,
operation, and maintenance.
2.3.2. EC Declaration of Conformity (for EU)
Refer to the EC declaration of conformity shipped with the device.
2.3.3. Control Drawings for FM & CSA
Refer to the control drawings shipped with the device.
2.3.4. Users
The mechanical and electrical installation must be carried out only by trained personnel
with knowledge of the requirements for installation of explosion-proof equipment in
hazardous areas.
The entire installation procedure must be carried out in accordance with national, local, and
company regulations.
The entire electrical installation shall be carried out in accordance with the national
requirements for electrical equipment to be installed in hazardous areas.
NOTE:
See EN IEC 60079-14 or NEC (NFPA70).
2.3.5. Additional Information
If you require additional information, contact Honeywell or its representative.
2.3.6. Environmental Conditions
Observe the environmental conditions for the temperature and the pressure.
Ambient Operating Temperature Range from -40°C (-40°F) up to +65°C (149°F).
To Next Page
Loading...
Need help?
General
