Part No: 4417341 Revision 10 Installation Manual 39
954 SmartServo FlexLine
MPT – MRT
Finishing Installation
CAUTION!
Make sure the separation between intrinsic and non intrinsic cabling is sufficient and
complies with any local and/or national regulations.
5.7.1. Assembling the Terminal Block and Board Compartment’s Lids
WARNING!
Make sure the surface of the O-ring grooves of the housing are clean and the O-rings
are not damaged before assembling the lids to the 954 SmartServo FlexLine housing.
Make sure that the both lids (used for terminal block and board compartments) do not
squeeze any cables during the assembly.
NOTE:
If existing installations have terminals 22 (V_Loop) and
23 (GND_Loop), VITO must be connected between them.
To Next Page
Loading...
Need help?
General
