EKZ000300C Page : 4/24
Installer instructions / Manuel installateur - Domonial CMI 800++ 11/2005
1-3 Transmitter function
The Domonial 800++ control panel includes a digital communicator designed to send information, via the PSTN or GSM (optional) network to:
- an Alarm Receiving Center using the following formats: Secom3, Surtec, Cesa, Stratel, Contact ID
- a telephone set.
The Domonial 800++ control panel can receive and integrate a full set of parameters from a remote position via the PSTN or GSM data
networks. Specific software and modem are necessary (depending on country rules).
8 call numbers / addresses (A, B, C, D, E, F, G, H) each containing a maximum of 20 digits can be programmed and designate:
- Phone numbers for PSTN or GSM calls > number can be entered using * for pause
- IP addresses for GPRS connections > use the following format : xxx.xxx.xxx.xxx:yyyy
xxx.xxx.xxx.xxx is the server IP address. Example: 192.168.0.56
yyyy is the port number : 443 is generally used.
A dialing prefix (within the maximum of 20 digits) can be programmed when a telephone exchange or a phone card is used.
The call sequences (up to 6) can be modified by the programming tool.
The CMI800++ includes an audio verification system.
With the GPRS optional module, the communicator can send pictures taken by the IRV800M detector/still camera.
It is possible to activate automation functions and surveillance arming (as it is programmed) via a DTMF telephone set.
The telephone line interface has built-in voltage surge protection and phone line failure detection.
For more details, see DomoPDA programming tool manual (EKZ000800)
PSTN network
Telephone set
Frontal receiver
(Alarm Receiving Center)
Remote maintenance
GSM and/or GPRS
GSM or GPRS
network
Domonial
Network
Audio / Pictures
Audio
To Next Page
Loading...
Need help?
General
