Honeywell Domonial CMI 800++ User Manual

EKZ000300C Page : 8/24
Installer instructions / Manuel installateur - Domonial CMI 800++ 11/2005
Hang-up
2-3 LED indicator lights
5 LED indicators show the control panel & transmitter status.
State / Indicator
Mains Power
Arm/Disarm
Perimeter fault
Alarm
memory
Technical
alarm
Color Green Green Red/Yellow Red Red
Off No mains power No area armed No fault No alarm No technical alarm
Slow Flashing
(2s-2s)
Cover tamper opened Annex or partial area
armed
One or more
perimeter detectors
are open
Alarm memory in
annex or partial area
One or more technical or
system alarm in memory
Quick Flashing
(1/4s-1/2s)
Cover tamper
opened and
transmission
in progress
- - - -
On steady Mains Power On Total area armed
-
Alarm memory in
total area
One or more technical
detector alarms in
progress
To comply with local rules, the signification of the LED can be different in some countries (see the User’s manual).
3 - PROGRAMMING
The Domonial panel can be programmed using:
- A PDA (Palm or Pocket PC) using the DomoPDA software. The connection to the panel is made with the “CAB800Palm” cable
and the PDA’s serial cable. Please see the EKZ000800 programming manual for more details.
- A PC using the “DOMOSTATION” or “DOMOPC” software depending on panel software version. The connection to the panel
is made with the “CAB800PC”
To use DOMOSTATION or DOMOPC as a remote tool, a modem “DOMODEM” has to be used. Please see the EKZ010200
programming manual for more details.
4 – OPERATION
4-1 Transmission to a DTMF telephone set
Once programmed Domonial++ can send information to a telephone set.
When a call is received and the handset is picked up the identification music is played
followed by a number of beeps corresponding to the triggered input. When several
devices have been triggered, only the first one is indicated.
After the message has been played, an acknowledgement is made by pressing the # key.
Then, if there is audio programmed, the site can be listened to remotely.
Hanging up terminates the call.
If the above configuration does not exist or if a decimal telephone is used, the message will be repeated using the programmed
sequence.
The identification music can be changed. When the DTMF remote code is even, Music 1 is played, when it is odd, Music 2 is played.
Mimic diagram
Press key:
Ringing Pick-up Identification Beeps Acknowledge Listen-in
Music 1
or music 2
Type 1 (by default) Type 2
Music 1
+ beep
Music 2
+ beep

Honeywell Domonial CMI 800++ Specifications

General

Brand	Honeywell
Model	Domonial CMI 800++
Category	Control Panel
Language	English