Mounting
14
► Set the date and time once automatic adaptation is complete.
Setting the date and time
The date and time must be set when first configuring the
controller and after each battery change (please also refer to
Page 13).
► Keep the button pressed for at least 2 seconds.
A four-digit number – the year – flashes in the display.
► Turn the adjusting ring until the current year is displayed.
► Press the button.
Two digits flash in the display for the month.
► Turn the adjusting ring until the current month is displayed.
► Press the button.
► Adapt the day, hour and minute by the same method until the current
setpoint temperature is displayed.
The date and time are set.
To Next Page
Loading...
Need help?
General
