– 27 –
USER FUNCTIONS
USER FUNCTIONSUSER FUNCTIONS
USER FUNCTIONS
Message Recording/Playback/Volume Control
The Lynx Plus Series Message Center allows you to record, play and delete messages. The maximum
message duration is 85 seconds.
NOTES: (1) The Record/playback functions can only be performed from the master keypad. It cannot be
performed from any other wireless keypad (ex. 5827).
(2) If the system loses electrical power, all messages will be erased.
(3) Message Play/Record will not be available if a report must be sent.
(4) Individual messages cannot be played back or deleted.
Recording a Message
To record a message: FUNCTION + RECORD
The keypad displays “Rec Press Off to Stop”. Begin speaking into the microphone.
The recording will automatically stop after 85 seconds, if a message has been recorded. The keypad will
beep twice and “Msg” will be displayed.
To stop recording before the end of 85 seconds: Press OFF
The keypad will beep twice, the “Rec Press Off to Stop” display turns off, but “Msg” is displayed.
Additional messages can be recorded, as long as there is recording time remaining, by repeating the
above steps.
NOTE: If you are trying to record a new message and the message center is already full, the system will
announce “End Message” and “Message Center Full” will be displayed. If the message center is
full all old messages must be deleted before new messages can be recorded. See Deleting
Messages section.
Message Playback
The display of “Msg” indicates that a new message is in memory. After playing the message, the
MESSAGE display turns off. See NOTE below if using a wireless keypad.
To play back a message:
FUNCTION + PLAY
All recorded messages will be announced sequentially. A short beep will sound between messages.
To skip a message: Press [✻]
Deleting Messages
To delete all messages:
FUNCTION + PLAY
While the messages are being announced: Press FUNCTION + DELETE
Two beeps will sound, confirming that the message(s) have been deleted.
To Next Page
Loading...
Need help?
General
