Maintenance
13.
Changing the Motorised Powerhead Drive Belt
WARNING: To reduce the risk of electrocution or injury, ensure the cleaner
is switched off and unplugged from the power supply before preforming any
maintenance.
Depending on how much your vacuum is used, the motorised
powerhead drive belt will occasionally require changing.
1. Disconnect the powerhead from the telescopic tube.
Cleaning the Motorised Powerhead
The rotating brush must be free of debris for effective cleaning
and maximum suction. Disconnect the motorised powerhead
and inspect the rotating brush. If a buildup of debris is visible
around the rotating brush, remove by carefully cutting with
scissors. Avoid damaging or cutting the bristles.
2. Turn the powerhead upside down and remove the small
screw from the centre of the powerhead.
DO NOT
OPEN
To Next Page
Loading...
Need help?
General
