Maintenance
15.
Part Part Number
Filter Set 32200832
Bag Holder 33101201
Dust Bag 5Pk 32410222
Hose Assembly 31210073
Rod 31300564
Troubleshooting
Problems and Solutions
If you come across a problem, please refer to the troubleshooting checklist below. If the problem still
persists, please contact Hoover Customer Care for further assistance.
Fault Solutions
The cleaner will not turn on. Check that the power cable is inserted securely; remove from the
power supply and then reinsert into the power supply.
Check that the on/off switch is in the “ON” position.
The vacuum performance
is deteriorating.
Check the appliance to ensure there are no blockages.
Clear any blockages that may be found.
Check that the air-inlet filter is not dusty; frequently clean rubbish or
replace air-inlet and air-outlet HEPA filters every 6 months.
The cleaner makes an
abnormal sound when
switched on.
Turn off the cleaner immediately.
Check the appliance to ensure there are no blockages.
Please clear any blockages that may be found.
Light on suction control dial is
illuminated or flashing.
This can be caused by a full dust bag or blockage within the hose
or rod.
Please contact Hoover Customer Care: 1300 360 845 or NZ: (09) 263 7573 to find your
local spare parts provider or for further assistance.
To Next Page
Loading...
Need help?
General
