Maintenance
13.
Motor Filter Cleaning
Warning: Ensure the cleaner is not connected to the mains power
supply when performing any maintenance procedures.
Press the dust canister release button to remove the dust canister
from the cleaner. Remove the top cover on the canister and
then remove the filter. The filter can be cleaned by using a brush
under luke warm water. Alternatively a new filter can be used as
a replacement.
CAUTION: It is normal that the white central filter
in the dust barrel may change colour, which will
not affect its filtration performance. If the hose
and the central filter are difficult to clean, it is
recommended to use warm water to clean;
ensure the filter is dry before reinstalling into
the cleaner.
Key Points:
Please note: when the dust canister or the filter cover
are not installed correctly, the cleaner will not function
correctly. If the cleaner is not functioning correctly,
check that the dust canister and the filter cover have
been installed correctly.
CAUTION: Ensure the suction passage
is always unobstructed, otherwise the
motor may overheat.
To Next Page
Loading...
Need help?
General
