10.
Refreshing carpets
1. Attach the Carpet Glider to the Floor Head.
2. Plug the steam cleaner into the main power. Press the power
switch, the blue ON light will illuminate.
3. After a few seconds half of the light will turn to red, indicating the
cleaner is ready for use.
4. Recline the cleaner by placing a foot on the Floor Head and
lowering the main body towards the floor.
5. To produce steam press the Steam Trigger.
6. Move the cleaner slowly backwards and forwards paying particular
attention to high traffic areas.
NOTE: Always sweep or vacuum the carpet prior to use to remove any loose dirt or debris.
IMPORTANT: Do not use the cleaner without a Mop Pad and carpet glider attached to the Floor Head.
Warning: Unplug the steamer and let the steamer cool down before you change the accessory.
Warning: Push the Detergent on/off button OFF before you are going to refresh carpet.
To Next Page
Loading...
Need help?
General
