9.
Instructions for Use
Steam cleaning hard floors
1. Plug the steam cleaner into the main power. Press the power
switch, the blue ON light will illuminate.
2. After a few seconds half of the light will turn to red, indicating the
cleaner is ready for use.
3. Recline the cleaner by placing a foot on the Floor Head and
lowering the main body towards the floor. Clip the power cable to
the cable holder.
4. To produce steam press the Steam Trigger Button.
5. Move the cleaner slowly backwards and forwards.
Note: Replace another dry mop pad if the floor is getting too wet.
NOTE: Always sweep or vacuum the floor prior to use to remove any loose dirt or debris.
IMPORTANT: Do not use the cleaner without a Mop Pad attached to the Floor Head.
NOTE: Do not use the Carpet Glider when cleaning hard floors.
WARNING: Unplug the steamer and let the steamer cool down before you change the
accessory.
To Next Page
Loading...
Need help?
General
