EasyManuals Logo

Hoover H-DISH 700 User Manual

Hoover H-DISH 700
Go to English
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #114 background imageLoading...
Page #114 background image
114
18.
WATER SOFTENER UNIT
Depending on the source of the supply,
water contains varying amounts of
limestone and minerals which are deposited
on the dishes leaving whitish stains and
marks. The higher the level of these
minerals present in the water, the harder
the water is. The dishwasher is fitted with a
water softener unit which, through the use
of special regenerating salt, supplies
softened water for washing the dishes. The
degree of hardness of your water can be
obtained from your water supply company.
The water softener can treat water with a
hardness level of up to 90 °fH (French grading)
or 50 °dH (German grading) through 8 settings.
The settings are listed in the table below,
with the relative mains water to be treated.
Level
Water hardness
Use of
Regenerating salt
Water softener
setting
°fH
(Franch)
°dH
(German)
0
0-5
0-3
NO
S0
1
6-10
4-6
YES
S1
2
11-20
7-11
YES
S2
3
21-30
12-16
YES
S3
4*
31-40
17-22
YES
S4
5
41-50
23-27
YES
S5
6
51-60
28-33
YES
S6
7
61-90
34-50
YES
S7
* The softener unit is set in the factory at
level 4 (S4) as this satisfies the requirements
of the majority of users.
Regulate the setting of your water softener
unit according to the degree of hardness of
your water, as follows:
1. Hold down the "PROGRAMME
SELECTION" button and at the same
time turn on the dishwasher with the
"ON/OFF" button for 5 seconds.
2. "SETUP" appears on the display.
3.
Press the
"PROGRAMME SELECTION"
button until you
see
"SOFTNER"
written
on the display.
4.
Then press either the button "HALF
LOAD"
or
"EXTRA DRY" to
change the value from S0 to S7.
5. Switch off the dishwasher by pressing
the "ON/OFF" button to confirm the
new setting.
To change the water softener setting again,
follow the same procedure.
WARNING
If you cannot complete the
procedure,
turn the dishwasher off by pressing
the
"ON/OFF" button and start the
procedure again from the beginning
(STEP 1).
The dishwasher must ALWAYS be off
before start of this procedure.
Regulating the water softener

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hoover H-DISH 700 and is the answer not in the manual?

Hoover H-DISH 700 Specifications

General IconGeneral
Built-in DisplayYes
AquaStop FunctionYes
Delayed Start TimerYes
Inlet Hose Length1.5 m
Outlet Hose Length1.5 m
Delayed StartUp to 24 hours

Related product manuals