P5
STEP 3:
Press the CARPET button to increase the
speed of the brushbar in order to deep
clean carpets.
The product is in carpet mode and the
brushbar status light will turn WHITE.
3. USING YOUR CLEANER
3.1 UPRIGHT MODE
STEP 1:
Plug the power cord into the socket.
Place your foot onto the nozzle and pull the handle
backwards to your desired operating level.
STEP 4:
Adjust the suction power by moving the
SUCTION CONTROL up or down.
1. MIN SETTING: minimum suction level
for long pile carpets or rugs.
2. MIDDLE SETTING: medium suction level
for medium pile carpets.
3. MAX SETTING: maximum suction level
for hard oors or short pile carpets.
Note: If the push force is too high and
the brushbar status light turns red, turn
o the product and move the SUCTION
CONTROL to MIDDLE or MIN setting.
STEP 5:
Turn your cleaner o by pressing the ON/OFF
button. Remove the plug from the power
socket and wind the power cable around the
the cord storage hook upper and lower.
STEP 2:
Press the ON/OFF button to operate your
cleaner.
The brushbar status light is OFF.
The product is in hard oor mode.
Nozzle LED lights are always ON, even if
the brushbar status light is OFF.
To avoid damaging the
power cord during use,
t the power cord into
the cord clip on the
handle.
To use your product in Upright mode:
To Next Page
Loading...
Need help?
General
