HP 13-C110NR User Manual

Setting Setup Utility (BIOS) passwords
Password Function
Administrator password
●
Must be entered each time you access Setup Utility (BIOS).
●
If you forget your administrator password, you cannot
access Setup Utility (BIOS).
Power-on password
●
Must be entered each time you turn on or restart the
computer.
●
If you forget your power-on password, you cannot turn on or
restart the computer.
To set, change, or delete an administrator or power-on password in Setup Utility (BIOS):
CAUTION: Use extreme care when making changes in Setup Utility (BIOS). Errors can prevent the computer
from operating properly.
NOTE: To start Setup Utility, your computer must be in notebook mode and you must use the keyboard
attached to your notebook. The on-screen keyboard, which displays in tablet mode, cannot access Setup
Utility.
1. Start Setup Utility (BIOS):
●
Computers or tablets with keyboards:
▲
Turn on or restart the computer, quickly press esc, and then press f10.
●
Tablets without keyboards:
1. Turn on or restart the tablet, and then quickly hold down the volume down button.
- or -
Turn on or restart the tablet, and then quickly hold down the Windows button.
2. Tap f10.
2. Select Security, and then follow the on-screen instructions.
Your changes take eect when the computer restarts.
Using the ngerprint reader (select products only)
Integrated ngerprint readers are available on select products.
To use the ngerprint reader, you must set up a user account and password on the computer and then
register one or more ngerprints using HP SimplePass software.
To register ngerprints with HP SimplePass:
1. Swipe a nger on the ngerprint sensor to launch HP SimplePass.
2. When the HP SimplePass welcome screen is displayed, select Get Started.
3. HP SimplePass prompts you to swipe your right index nger over the sensor.
Using the ngerprint reader (select products only) 41

HP 13-C110NR Specifications

General

Brand	HP
Model	13-C110NR
Category	Laptop
Language	English