HP 15-eg0000 User Manual

To protect a memory module after removal, place it in an electrostatic-safe container.
To install a memory module:
1. Align the notched edge of the module with the tab in the slot (1), and then press the module into the slot
at an angle until it is seated (2).
2. Press down on the module until the side retention clips snap into place (3).
USB board
To remove the USB board, use this procedure and illustration.
34 Chapter 5 Removal and replacement procedures for authorized service provider parts

HP 15-eg0000 Specifications

General

Brand	HP
Model	15-eg0000
Category	Laptop
Language	English