HP 15 Series User Manual

TouchPad button board
Table 6-10 TouchPad button board part descriptions and part numbers
Description Spare part number
TouchPad button board not spared
Before removing the TouchPad button board, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 33).
2. Remove the optical drive (see Optical drive on page 34).
3. Remove the bottom cover (see Bottom cover on page 38).
4. Remove the battery (see Battery on page 41).
Remove the TouchPad button board:
1. Disconnect the system board cable from the ZIF connector on the TouchPad button board (1).
2. Disconnect the TouchPad cable from the ZIF connector on the TouchPad button board (2).
3. Remove the two Phillips M2.0 × 3.0 screws (3) that secure the board to the computer.
4. Remove the TouchPad button board from the computer (4).
Reverse this procedure to install the TouchPad button board.
Component replacement procedures 53

HP 15 Series Specifications

General

Brand	HP
Model	15 Series
Category	Laptop
Language	English