HP 8710p - Compaq Business Notebook User Manual

System board
NOTE: Replacement thermal material is included with all system board spare part kits.
Description Spare part number
For use only with computer models equipped with processors with 3- or 6-MB L2 cache 468591-001
For use only with computer models equipped with processors with 2- or 4-MB L2 cache 450482-001
Before removing the system board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the following components:
a. Battery (see
Battery on page 44)
b. Hard drive (see
Hard drive on page 48)
c. Bluetooth module (see
Bluetooth module on page 51)
d. Optical drive (see
Optical drive on page 58)
e. Keyboard (see
Keyboard on page 60)
f. TouchPad (see
TouchPad on page 64)
g. Switch cover (see
Switch cover on page 67)
h. Fan/heat sink assembly (see
Fan/heat sink assembly on page 70)
i. Graphics card (see
Graphics card on page 72)
j. Processor heat sink (see
Heat sink on page 74)
k. Display assembly (see
Display assembly on page 77)
l. Top cover (see
Top cover on page 83)
m. Speaker assembly (see
Speaker assembly on page 85)
When replacing the system board, be sure that the following components are removed from the defective
system board and installed on the replacement system board:
●
Memory modules (see
Primary memory module on page 52 and Expansion memory module
on page 63)
●
WLAN module (see
WLAN module on page 54)
●
RTC battery (see
RTC battery on page 57)
●
Modem module (see
Modem module on page 66)
Component replacement procedures 87

HP 8710p - Compaq Business Notebook Specifications

General

Brand	HP
Model	8710p - Compaq Business Notebook
Category	Laptop
Language	English