HP b2600 User Manual

18 Chapter2
SCR Overview
Checking Data Collection Status
Checking Data Collection Status
To check data collection status of all registered nodes, use the scrsta-
tus command. This provides a summary report of the last, current, and
scheduled data collection for all registered nodes, in time order.
# scrstatus
The report, printed to stdout, resembles the following example:
TIME (START – STOP) NODE STATUS DETAIL
02/06/199912:05 – 12:08 PST elsa Completed
02/06/199912:15 – 12:17 PST ortrud Warning - AcErr -
02/07/199916:37 - PST ortrud Executing
02/07/199900:05 - PST ortrud Scheduled
02/07/199912:05 - PST elsa Scheduled
This report appears in three blocks separated by vertical space. The
first block above (the first two lines) reports the most recent data
collection. The second block shows data collection being performed. The
last block shows future scheduled data collection. Some of these blocks
might be empty, especially when SCR is first installed.

HP b2600 Specifications

General

Form Factor	Tower
RAM	256 MB DDR SDRAM (expandable to 2 GB)
Graphics	Integrated
Audio	Integrated
Networking	10/100Base-T Ethernet
Front Ports	2 USB 2.0, audio jacks
Rear Ports	Serial, Parallel, Ethernet

Summary

Introduction to HP-UX System Configuration Repository (SCR)

Key SCR Features

Summarizes SCR's ability to take snapshots, compare configurations, and monitor systems for proactive management.

SCR Operational Guide

SCR Installation and Initial Setup

Explains SCR installation requirements and the two management system types: CMS and Managed Nodes.

SCR Configuration and Data Scheduling

Guides on registering managed nodes and defining automated data collection schedules for system configurations.

SCR Monitoring and Reporting

Details commands for checking collection status, viewing node configurations, and tracking historical changes.

Advanced SCR Features and Use Cases

Explains tagging for easy naming, filtering for selective viewing, and applications like inventory and disaster recovery.

SCR Command Reference

scrconfig: Configuration Management

Details the scrconfig command for managing SCR parameters, including node lists, schedules, and expiration.

scrdiff: Identifying Configuration Differences

Describes the scrdiff command for identifying and reporting differences between system configuration snapshots.

scrfilter: Managing Data Filters

Covers the scrfilter command for creating, modifying, and deleting view and collection filters.

scrhist: Tracking Configuration History

Details the scrhist command for listing and reviewing the history of SCR snapshots.

scrupdate: Collecting Configuration Data

Explains the scrupdate command for collecting system configuration data from managed nodes.

SCR Fileset Overview

SCR Fileset Contents

Provides information on the SCR filesets (SCR-RUN, SCR-MAN, SCR-MX) and how to view their contents.