HP Compaq dx7300 ST User Manual

Removing the Computer from the Stand
When accessing internal components, remove the computer from the stand before removing the
computer cover. To remove the computer from the stand:
1. Remove/disengage any security devices that prohibit opening the computer.
2. Remove all removable media, such as diskettes or compact discs, from the computer.
3. Turn off the computer properly through the operating system, then turn off any external devices.
4. Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION Regardless of the power-on state, voltage is always present on the system
board as long as the system is plugged into an active AC outlet. You must disconnect the
power cord to avoid damage to the internal components of the computer.
5. Lift the computer off the stand.
Figure 2-1 Removing the Computer from the Computer Stand
NOTE Lay the computer on its side (with the computer cover facing up) before removing the
computer cover and installing hardware.
10 Chapter 2 Hardware Upgrades ENWW

HP Compaq dx7300 ST Specifications

General

Brand	HP
Model	Compaq dx7300 ST
Category	Desktop
Language	English