Power
Hardware and Software Guide 2–30
Recharging the Battery Pack
Ä
CAUTION: To prevent an unintended battery drain and a potential loss of
work when the notebook reaches a critical low-battery condition, reenable
hibernation after calibrating the battery pack. To reenable hibernation:
Select Start > Control Panel > Performance and Maintenance >
Power Options > Hibernate. Select the Enable hibernation check
box, and then select OK.
To recharge the battery pack:
1. Connect the notebook to external power and maintain the
connection until the battery pack is fully recharged. (The
battery light on the notebook will then be turned
off.)
You can use the notebook while the battery pack is recharging
but the battery pack will charge faster if the notebook is off.
2. If the notebook is off, turn it on when the battery pack is fully
charged and the battery light is turned off.
3. Access the Power Schemes tab by selecting Start > Control
Panel
> Performance and Maintenance > Power
Options
> Power Schemes tab.
4. Refer to the settings you recorded earlier. Reenter the settings
that you recorded for the items in the Plugged In column and
the Running on Batteries column.
5. Select OK.
To Next Page
Loading...
Need help?
General