HP DL385 - ProLiant - G5 User Manual

Hardware options installation 53
1.
Remove the power supply blank.
WARNING: To reduce the risk of electric shock or damage to the equipment, do not connect
the power cord to the power supply until the power supply is installed.
2. Slide the power supply into the power supply bay until the release/lock lever clicks, securing the
power supply.
3. Connect the power cord to the power supply.
4. Tighten the two retaining screws on either side of the power cord connector.
5. Route the power cord:
o If the cable management arm has a left-hand swing, route the power cord through the cable
management arm.
o If the cable management arm has a right-hand swing, remove the cable management arm or
convert it for left-hand swing. For removal instructions, see "Cable management arm with right-
hand swing (on page 29)." For conversion instructions, see the instructions that ship with the 2U
Quick Deploy Rail System.

HP DL385 - ProLiant - G5 Specifications

General

Processor	AMD Opteron
Processor Socket	Socket F (1207)
Maximum Processors	2
Memory Slots	16
Maximum Memory	128 GB
Form Factor	2U Rack
Product Line	ProLiant
Model	DL385 G5
Hard Drive Interface	SAS/SATA
Memory Type	DDR2
Storage	SAS/SATA
Drive Bays	8
RAID Levels	RAID 0, 1, 5
Network	Embedded NC373i Multifunction Gigabit Network Adapter
Network Controller	HP NC373i
Expansion Slots	6
Power Supply	Hot-plug redundant power supplies
Operating System Support	Windows Server, Linux, VMware
Server Type	Rack