52
To replace an HMIM:
1. Completely loosen the captive screws of the HMIM.
2. Gently pull the HMIM out of the slot along the slide rails.
3. Install a new HMIM. For the installation procedure, see "Installing the router."
If you do not install a new HMIM, install a filler panel and tighten the screws.
Figure 73 Pulling the HMIM out of the slot
Figure 74 Installing a filler panel
Replacing a MIM
WARNING!
You can replace a MIM when the router is powered on. However, before replacing a MIM when the
router is powered on, you must execute the remove hmimslot slotnumber command.
To replace a MIM:
1. Completely loosen the captive screws of the HMIM adapter.
2. Gently pull the MIM and the HMIM adapter out of the slot along the slide rails.
To Next Page
Loading...
Need help?
General
