2-1
Installing the Switch
2
Installing the Switch
The ProCurve Series 2600 Switches come with an accessory kit that includes
the brackets for mounting the switch in a standard 19-inch telco rack, in an
equipment cabinet, or on a wall. The brackets are designed to allow mounting
the switch in a variety of locations and orientations. Rubber feet are provided
that can be attached so the switch can be securely located on a horizontal
surface.
This chapter shows you how to install your Series 2600 Switches.
Included Parts
The Series 2600 Switches have the following components:
■ ProCurve Series 2600 Switches Installation and Getting Started Guide
(5991-2165), this manual
■ ProCurve Manager - CD ROM and booklet
■ Console cable
■ Customer Support/Warranty booklet
■ Accessory kits
Switches 2626 and 2650 Non-PWR
and Switch 2600-8-PWR
Switches 2626-PWR and
2650-PWR
Kit number 5069-6535
Contains:
• two mounting brackets
• eight 8-mm M4 screws to attach the
mounting brackets to the switch
• four 5/8-inch number 12-24 screws to
attach the switch to a rack
• four rubber feet
Kit number 5069-5705
Contains:
• two mounting brackets
1
• eight 8-mm M4 screws to attach the
mounting brackets to the switch
• four 5/8-inch number 12-24 screws to
attach the switch to a rack
• four rubber feet
1
The mounting brackets in this kit are longer to support the increased depth of the 2626-
PWR and 2650-PWR products.
To Next Page
Loading...
Need help?
General
