EasyManuals Logo
Home>HP>Switch>J9145A

HP J9145A User Manual

HP J9145A
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #58 background imageLoading...
Page #58 background image
3-2
Getting Started With Switch Configuration
Using the Console Setup Screen
Getting Started With Switch
Configuration
Note By default, the switch is configured to acquire an IP address configuration
from a DHCP or Bootp server. To use DHCP/Bootp instead of the manual
method described in this chapter, see “DHCP/Bootp Operation” in the
Management and Configuration Guide, which is on the ProCurve Website at
www.procurve.com/manuals.
Using the Console Setup Screen
The quickest and easiest way to minimally configure the switch for manage-
ment and password protection in your network is to use a direct console
connection to the switch, start a console session, and access the Switch Setup
screen.
1. Using the method described in the preceding section, connect a terminal
device to the switch and display the switch console command (CLI)
prompt (the default display).
The CLI prompt appears displaying the switch model number:
ProCurve Switch 2910al-48G#
2. At the prompt, enter the setup command to display the Switch Setup
screen. The following illustration shows the Setup screen with the default
settings.
3. Use the
[Tab] key to select the Manager Password field and enter a manager
password of up to 16 characters.
2910al-48G
2910al-48G
5
8

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP J9145A and is the answer not in the manual?

HP J9145A Specifications

General IconGeneral
BrandHP
ModelJ9145A
CategorySwitch
LanguageEnglish

Related product manuals